ST05 - OXYGEN SENSOR TESTER/Simulator
This high-tech, user friendly Oxygen Sensor Tester/Simulator from General Technologies Corp sports a simple interface to perform
diagnostic tests on any Oxygen Sensor to quickly determine whether the Sensor is defective and needs replacement.
It is designed to be used both, as a stand alone tool or as a compliment to any scanner during the diagnostic process.
Can be used on all oxygen sensors:
Zirconium Sensors
Titanium 1 volt sensors
Titanium 5 volt Sensors
Wide Band "dual-Cell" Sensors.
Heated or unheated Sensors (1,2,3,4 or 5 wires)
Advantages:
Simple to set-up and use
Fast and accurate testing of sensor. Output signal shown in real time on bar graph
Diagnose "Lazy" sensors which may not trigger DTC's but cause driveability problems
Simulate Sensor Outputs
Determine and locate faulty sensor
Sensor can be tested either ON or OFF vehicle
Does not require special time-consuming set-up or in-depth knowledge
Real time cross count displayed on live bar graph
Instant sensor PASS/FAIL result shown on large alpha-numeric display
Additional Features:
Rugged construction, manufactured in North America
42 V Ready
Internally protected against power surges, overloads and reversed polarity connections
Bright and powerful LED bar graph for sensor signal
Cross count displayed on 2 digit alphanumeric LED display
High temperature silicone 16 AWG test wires and rugged piercing clamps
Protective rubber holster
ST05 Oxygen Sensor Tester/Simulator comes complete with:
ST05 Tester/simulator
Protective rubber holster
Polypropylene carrying case
9 volt battery
Comprehensive User's manual.
No comments:
Post a Comment